Frequently
Asked
Questions

Frequently Asked Questions

KOOI-REACHFORKS® Troubleshooting FAQ

Oil Leak between Cylinder Head and Piston Rod

Possible Causes:
– Bent piston rod
– Scratched/damaged piston rod
– Leaking piston seal

Solutions:
– Replace piston rod and cylinder head if bent.
– Replace cylinder head if piston seal is leaking.

Oil Leak between Cylinder Head and Fork Blade

Possible Cause:
– Leaking O-Ring

Solution:
– Replace cylinder head.

Oil Leak at Connector

Possible Causes:
– Leaking copper ring
– Loose connector

Solutions:
– Replace copper ring.
– Tighten connector.

Forks Leaking Oil

Possible Cause:
– One or both KOOI-REACHFORKS® are cracked.

Solution:
– Remove KOOI-REACHFORKS® from the carriage immediately and contact the supplier.

Forks Moving Unevenly (More than 4%)

Possible Causes:
– A piston seal is leaking.
– The hydraulic hoses are wrongly connected.
– The length of the piston rods is unequal.
– Flow of hydraulic oil is not between 8-25 L/min.
– Dirt in the sleeve(s).
– Flow divider is damaged.

Solutions:
– Replace the piston with the leaking seal.
– Connect the hoses as indicated in the assembly chapter.
– Install piston rods of equal length.
– Contact your supplier to ensure proper hydraulic oil flow.
– Dismantle sleeve and remove dirt.
– Replace flow divider.

One or Both Sleeves Move Without Being Operated

Possible Causes:
– The control valve is leaking.
– There is air in the hydraulic system.
– A piston seal is leaking.

Solutions:
– Inform your forklift supplier to fix the control valve.
– Bleed the hydraulic system.
– Replace the piston with the leaking seal.

One Sleeve Remains Stationary During Retraction then Suddenly Retracts Quickly

Possible Cause:
– Clamping bush(es) broken.

Solution:
– Replace the clamping bush(es).

One of the Sleeves Fails to Retract

Possible Causes:
– Difference in length between the sleeves.
– Loose piston.

Solutions:
– Contact your supplier to check and fix the stroke length difference.
– Dismantle outer fork, remove hydraulic set from fork and tighten piston to 70 Nm.

Difference in Height Between Forks

Possible Causes:
– One of the KOOI-REACHFORKS® has been permanently deformed as a result of overloading.
– One of the KOOI-REACHFORKS® is not hanging on the carriage plate.
– Carriage plate is not completely horizontal.
– The forks do not match (forks belong to different sets).
– Wear strips on one KOOI-REACHFORK® are more worn than the other.

Solutions:
– Remove KOOI-REACHFORKS® from the carriage immediately and contact the supplier.
– Hang the KOOI-REACHFORK® properly onto the carriage plate and check the locking mechanism.
– Contact your forklift truck supplier to ensure the carriage plate is horizontal.
– Check the serial numbers to confirm that the forks belong to the same set.
– Replace worn wear strips.

Excessive Play Between Fork Blade and Sleeve

Possible Causes:
– Wear strips worn out.
– Sleeves worn out.

Solutions:
– Replace wear strips.
– Replace sleeves.

These solutions are derived from the troubleshooting section of the KOOI-REACHFORKS® instruction manual【7†source】. For further details, refer to the specific sections in the manual.